Refrigeration System Evacuation | Öztek
Mon – Sat 08:30 – 18:30  ·  Installation & after-sales service across Türkiye and abroad 0532 703 19 21 sales@ozteksogutma.com.tr

Evacuating a Refrigeration System: Why It Matters and How to Do It

31 Ekim 2026 · Öztek Soğutma Knowledge Hub
Öztek 100120 kW endüstriyel chiller

Evacuating a refrigeration system means removing air and moisture from a new or repaired system before it is charged with refrigerant. If this step is skipped or done poorly, acid can form, the expansion valve can freeze and compressor life shortens. This article explains why evacuation matters and how to do it correctly.

Why evacuate?

Air left in the system collects in the condenser as non-condensable gas and raises discharge pressure. Moisture can combine with refrigerant and oil to form acid, and can freeze in the expansion valve and block it. Evacuation removes both enemies from the system.

For a proper vacuum

Pressure test first

Before evacuation the system should be pressure tested with nitrogen. If there is a leak, the vacuum cannot be reached or the reading rises during the standing test. Refrigerant must not be charged until the leak is fixed.

Consequences of poor vacuum

High discharge pressure, low efficiency, valve blockage, oil breakdown and, in the long run, compressor failure. A few hours spent on evacuation prevent expensive failures later.

Frequently asked questions

How long should evacuation take?

Time is not what counts; the vacuum level reached and the standing test result decide.

Is nitrogen purging necessary?

Flowing nitrogen during brazing prevents oxide forming inside the pipes; nitrogen is also used for the pressure test.

Tell us about your project. Send your product, quantities and location via WhatsApp or e-mail; our engineers will calculate the load and recommend the right system in writing.

Bu konu için teklif alın